Bpdu-Tunnel Tunnel-Dmac - H3C S7500E Series Command Reference Manual

By default, BPDU tunneling for any protocol is disabled.
Note that:
Settings made in Ethernet interface view or Layer 2 aggregate interface view take effect only on
the current port; settings made in port group view take effect on all ports in the port group.
You cannot enable BPDU tunneling on a member port of a service loopback group.
Before enabling BPDU tunneling for DLDP, EOAM, GVRP, HGMP, LLDP, or STP on a port,
disable the protocol on the port first. Because PVST is a special STP protocol, before enabling
BPDU tunneling for PVST on a port, you must also disable STP and then enable BPDU tunneling
for STP on the port first.
Before enabling BPDU tunneling for LACP on a member port of a link aggregation group, remove
the port from the link aggregation group first.
Examples
# Disable STP on GigabitEthernet 2/0/1, and then enable BPDU tunneling for STP on the port.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-gigabitethernet2/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] bpdu-tunnel dot1q stp
# Disable STP for port group 1, and then enable BPDU tunneling for STP in the port group.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 2/0/1 to gigabitethernet 2/0/6
[Sysname-port-group-manual-1] undo stp enable
[Sysname-port-group-manual-1] bpdu-tunnel dot1q stp
# Disable STP on Layer 2 aggregate interface 1, and then enable BPDU tunneling for STP on the port.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] undo stp enable
[Sysname-Bridge-Aggregation1] bpdu-tunnel dot1q stp

bpdu-tunnel tunnel-dmac

Syntax
bpdu-tunnel tunnel-dmac mac-address
undo bpdu-tunnel tunnel-dmac
View
System view
Default Level
2: System level
Parameters
mac-address: Destination multicast MAC address for BPDUs, in the format of H-H-H. The allowed
values are
0x010F-E200-0003.
0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1,
12-2
0x0100-0CCD-CDD2, and