H3C S7500E Series Command Reference Manual page 330

Description
Use the remark service-vlan-id command to configure the action of setting the specified SVLAN ID
for packets.
Use the undo remark service-vlan-id command to remove the action.
Note that:
If the remark service-vlan-id action will be applied to the inbound direction of a port or port
group on an EA LPU, the classification rule must be configured with the if-match
customer-vlan-id command, and the other actions except remark dot1p cannot be configured in
the traffic behavior.
If the remark service-vlan-id action will be applied to the outbound direction of a port or port
group on an SC LPU, any other actions except filer and remark dot1p cannot be configured in
the traffic behavior.
The remark service-vlan-id action cannot be applied to a VLAN or applied globally.
Examples
# Create a traffic behavior named b1, and configure the action of marking packets with SVLAN ID 222
for the traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior b1
[Sysname-behavior-b1] remark service-vlan-id 222
19-3