H3C S7500E Series Command Reference Manual page 337

regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display lldp neighbor-information command to display the LLDP information carried in
LLDP TLVs sent from the neighboring devices.
Examples
# Display the LLDP information sent from the neighboring devices received through all the ports.
<Sysname> display lldp neighbor-information
LLDP neighbor-information of port 1[GigabitEthernet2/0/1]:
Neighbor index
Update time
Chassis type
Chassis ID
Port ID type
Port ID
Port description : GigabitEthernet2/0/1 Interface
System name
System description : System
System capabilities supported : Bridge,Router
System capabilities enabled
Management address type
Management address
Management address interface type : IfIndex
Management address interface ID
Management address OID
Port VLAN ID(PVID): 1
Port and protocol VLAN ID(PPVID) : 1
Port and protocol VLAN supported : Yes
Port and protocol VLAN enabled
VLAN name of VLAN 1: VLAN 0001
Auto-negotiation supported : Yes
Auto-negotiation enabled
OperMau
Power port class
PSE power supported
PSE power enabled
PSE pairs control ability : No
Power pairs
Port power classification : Class 0
Link aggregation supported : Yes
Link aggregation enabled
: 1
: 0 days,0 hours,1 minutes,1 seconds
: MAC address
: 000f-0055-0002
: Interface name
: GigabitEthernet2/0/1
: Sysname
: Bridge,Router
: ipv4
: 192.168.1.55
: Unknown
: 0
: No
: Yes
: speed(1000)/duplex(Full)
: PD
: No
: No
: Signal
: No
20-7