H3C S7500E Series Command Reference Manual page 163

Field
Last clearing of counters
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interface(s) under
route mode:
Link: ADM - administratively down; Stby -
standby
Protocol: (s) - spoofing
Interface
Time when statistics on the logical interface were last cleared by
using the reset counters interface command.
If the statistics of the interface have never been cleared by using
the reset counters interface command since the device starts,
Never is displayed for this field.
Average input rate over the last 300 seconds, where:
packets/sec indicates the average number of packets
received per second.
bytes/sec indicates the average number of bytes received
per second.
bits/sec indicates the average number of bits received per
second.
Average output rate over the last 300 seconds, where:
packets/sec indicates the average number of packets sent
per second.
bytes/sec indicates the average number of bytes sent per
second.
bits/sec indicates the average number of bits sent per
second.
Total number and size (in bytes) of the input packets of the
interface and the number of the dropped packets
Total number and size (in bytes) of the output packets of the
interface and the number of the dropped packets
The command displays brief information about Layer 3
interfaces
AMD indicates that the interface has been shut down by the
network administrator. To recover its physical layer state,
perform the undo shutdown command.
Stby indicates that the current interface is a standby interface.
If the network layer protocol state of an interface is shown as
UP, but its link is an on-demand link or not present at all, its
protocol attribute includes the spoofing flag (an s in
parentheses).
Interface name
6-4
Description