H3C S7500E Series Command Reference Manual page 357

protocol-vlan-id: Advertises port and protocol VLAN ID TLVs.
vlan-name: Advertises VLAN name TLVs.
vlan-id: ID of the VLAN in the TLVs to be advertised. This argument ranges from 1 to 4094 and defaults
to the least VLAN ID on the port.
dot3-tlv: Advertises IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Advertises link aggregation TLVs.
mac-physic: Advertises MAC/PHY configuration/status TLVs.
max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power via MDI TLVs and power stateful control TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises the following TLVs: hardware revision, firmware revision, software revision,
serial number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
civic-address: Inserts the normal address information about the network device in location
identification TLVs .
device-type: Device type value, in the range of 0 to 2. Value 0 specifies a DHCP server. Value 1
specifies a switch. Value 2 specifies an LLDP-MED endpoint.
country-code: Country code, corresponding to ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information, where ca-type represents the address
information type, in the range 0 to 255, ca-value represents address information, which is a string of 1
to 250 characters, and &<1-10> indicates that you can enter up to ten such parameters.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Telephone number for emergencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Description
Use the lldp tlv-enable command to configure the types of advertisable TLVs for a port or all the ports
in a port group.
Use the undo lldp tlv-enable command to disable the advertising of specific types of TLVs.
By default, all types of LLDP TLVs, except location identification TLVs, are advertisable.
To enable the device to advertise LLDP-MED TLVs, you must first enable it to advertise LLDP-MED
capabilities TLVs. Conversely, to disable the device from advertising LLDP-MED capabilities TLVs, you
must first disable it from advertising other LLDP-MED TLVs.
To disable the device from advertising MAC/PHY configuration/status TLVs, you must first disable it
from advertising LLDP-MED capabilities TLVs.
If you enable the device to advertise LLDP-MED capabilities TLVs, you also enable it to advertise
MAC/PHY configuration/status TLVs.
To enable the device to advertise multiple types of TLVs, you can execute the lldp tlv-enable
command repeatedly without the all keyword specified.
20-27