Table 21-1 display service-loopback group command output description
Field
Service Group ID
Quote Number
Service Type
Member
Status
port service-loopback group
Syntax
port service-loopback group number
undo port service-loopback group
View
Layer 2 Ethernet interface view
Default Level
2: System level
Parameters
number: Service loopback group ID. The value range for the number argument is 1 to 1024.
Description
Use the port service-loopback group command to assign the current port to the specified service
loopback group.
Use the undo port service-loopback group command to remove the current port from the specified
service loopback group.
By default, a port does not belong to any service loopback group.
Note that:
To assign multiple ports to a service loopback group, run this command on multiple ports
separately.
You cannot remove the last member port of a referenced service loopback group.
Service loopback group ID
Reference count of the service loopback group
Service type of the service loopback group, which can be one of the following:
Multicast tunnel, supporting multicast tunnel traffic
Tunnel, supporting unicast tunnel traffic
Member ports of the service loopback group
Port state, which can be selected or unselected
21-2
Description