Gvrp - H3C S7500E Series Command Reference Manual

Parameters
timer-value: Leaveall timer setting (in centiseconds), which must be a multiple of 5 in the range of the
maximum Leave timer on the device (exclusive) and 32765 (inclusive).
Description
Use the garp timer leaveall command to set the GARP LeaveAll timer.
Use the undo garp timer leaveall command to restore the default. This may fail if the default is
beyond the valid value range for the LeaveAll timer.
By default, the setting of the LeaveAll timer is 1000 centiseconds.
Related commands: display garp timer and garp timer leave.
Examples
# Set the leaveall timer to 100 centiseconds, assuming that the Leave timer on every port is set to 60
centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 100

gvrp

Syntax
gvrp
undo gvrp
View
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
None
Description
Use the gvrp command to enable GVRP.
Use the undo gvrp command to disable GVRP.
By default, GVRP is disabled.
Note that:
Settings in system view take effect globally; Settings in Ethernet view or Layer 2 aggregate
interface take effect on the current interface. Settings in port group view take effect on all ports in
the port group.
To enable GVRP on a port, enable GVRP globally first and then on the port.
You can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
Related commands: display gvrp status.
Examples
# Enable GVRP globally.
17-10