H3C S7500E Series Command Reference Manual page 285

ports. If it fails to do that on an aggregation member port, it simply skips the port and moves to the
next port. For more information about Layer 2 aggregate interfaces, see Ethernet Link
Aggregation Configuration in the Layer 2 – LAN Switching Configuration Guide.
Before issuing this command, make sure that you have made the following configurations:
Create a VLAN and associate it with specified protocols.
Configure the link type as hybrid.
Configure the port to allow the protocol-based VLAN to pass through.
Related commands: display protocol-vlan interface.
Examples
# Associate the hybrid port GigabitEthernet 2/0/1 with protocol 0 (AppleTalk) in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan at
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] port link-type hybrid
[Sysname-GigabitEthernet2/0/1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-GigabitEthernet2/0/1] port hybrid protocol-vlan vlan 2 0
# Associate the hybrid Layer 2 aggregate interface Bridge-aggregation 1 with protocol 0 in VLAN 2,
assuming that Bridge-aggregation 1 does not have member ports.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan at
[Sysname-vlan2] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0
# Associate the hybrid Layer 2 aggregate interface Bridge-aggregation 1 with protocol 0 in VLAN 2.
Among the member ports of the aggregation group corresponding to Bridge-aggregation 1,
GigabitEthernet 2/0/2 is an access port and GigabitEthernet 2/0/3 is a trunk port.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan at
[Sysname-vlan2] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type access
Please wait... Done.
Configuring GigabitEthernet2/0/2... Done.
Configuring GigabitEthernet2/0/3........................................... Done.
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring GigabitEthernet2/0/2... Done.
Configuring GigabitEthernet2/0/3... Done.
13-29