Protocol-Vlan - H3C S7500E Series Command Reference Manual

Lan switching
Hide thumbs Also See for S7500E Series:
Table of Contents

Advertisement

[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0

protocol-vlan

Syntax
protocol-vlan [ protocol-index ] { at | ipv4 | ipv6 | ipx { ethernetii | llc | raw | snap } | mode
{ ethernetii etype etype-id | llc { dsap dsap-id [ ssap ssap-id ] | ssap ssap-id } | snap etype
etype-id } }
undo protocol-vlan { protocol-index [ to protocol-end ] | all }
View
VLAN view
Default Level
2: System level
Parameters
at: Specifies the AppleTalk based VLAN.
ipv4: Specifies the IPv4 based VLAN.
ipv6: Specifies the IPv6 based VLAN.
ipx: Specifies the IPX based VLAN. The keywords ethernetii, llc, raw, and snap are encapsulation
formats for IPX.
mode: Configures a user-defined protocol template for the VLAN, which could also have four
encapsulation formats, namely, ethernetii, llc, raw, and snap.
ethernetii etype etype-id: Specifies to match Ethernet II encapsulation format and the corresponding
protocol type values. The etype-id argument is the protocol type ID of inbound packets, in the range
0x0600 to 0xffff (excluding 0x0800, 0x809b, 0x8137, and 0x86dd).
llc: Specifies to match the llc encapsulation format.
dsap dsap-id: Specifies the destination service access point, in the range of 00 to 0xff.
ssap ssap-id: Specifies the source service access point, in the range of 00 to 0xff.
snap etype etype-id: Specifies to match SNAP encapsulation format and the corresponding protocol
type values. The etype-id argument is the Ethernet type of inbound packets, in the range 0x0600 to
0xffff (excluding ipx snap under the snap encapsulation format).
protocol-index: Protocol index, which specifies the protocol template to be bound with the current
VLAN. Its range varies by device. System will automatically assign an index if this parameter is not
specified.
to protocol-end: Specifies the end protocol index, whose range varies by device. The protocol-end
argument must be greater than or equal to the protocol-index argument.
all: Specifies to remove all the protocols bound with the current VLAN.
13-30

Advertisement

Table of Contents
loading

Table of Contents