View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number of an ONU, in the range 1 to the number of UNI ports of the current ONU.
The number of UNIs can be up to 80.
text: String of 1 to 40 characters describing the UNI.
Description
Use the uni description command to configure a description for a UNI.
Use the undo uni uni-number description command to restore the default.
By default, no description is configured for a UNI.
Examples
# Configure the description of UNI 1 as Test.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 description Test
uni duplex
Syntax
uni uni-number duplex { full | half | auto }
undo uni uni-number duplex
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
full: Specifies the port to be in full duplex mode.
half: Specifies the port to be in half duplex mode.
auto: Specifies the duplex mode of the port to be auto-negotiation.
Description
Use the uni duplex command to set the duplex mode for UNIs.
Use the undo uni duplex command to restore the duplex mode on the current port to the default
value.
By default, the duplex mode on UNIs is full.
This command takes effect on H3C ONUs only.
3-28