H3C S7500E Series Command Reference Manual page 20

GE2/0/3 UP
GE2/0/4 UP
# Display the brief information about all but Ethernet interfaces.
<Sysname> display interface brief | exclude GE
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP
NULL0 UP
Vlan1 UP
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed
BAGG1 DOWN auto
# Display information about interfaces in DOWN state and the relevant causes.
<Sysname> display interface brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
GE2/0/8 DOWN Not connected
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
BAGG1 DOWN Not connected
GE2/0/1 DOWN Not connected
GE2/0/2 DOWN Not connected
GE2/0/4 DOWN Not connected
GE2/0/5 DOWN Not connected
Table 1-1 display interface brief command output description
Field
The brief information of
interface(s) under route
mode:
Link: ADM -
administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
1G F A 3
100M(a) F(a) A 1
UP(s) --
UP 192.168.0.102
Duplex Type PVID Description
A A 1
The command displays brief information about Layer 3 interfaces
AMD indicates that the interface has been shut down by the network
administrator. To recover its physical layer state, perform the undo shutdown
command.
Stby indicates that the current interface is a standby interface.
If the network layer protocol state of an interface is shown as UP, but its link is an
on-demand link or not present at all, its protocol attribute includes the spoofing
flag (an s in parentheses). This attribute is typical of interface Null 0 and the
loopback interfaces.
Interface name
1-5
Description
Description