Port Trunk Pvid - H3C S7500E Series Command Reference Manual

<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port trunk permit vlan 13 15
Please wait... Done.
Error: Failed to configure on interface GigabitEthernet2/0/2! This port is not a Trunk port!
Configuring GigabitEthernet2/0/3... Done.
Among the output fields above, the message "Please wait... Done" indicates that the configuration on
Bridge-aggregation 1 succeeded; "Error: Failed to configure on interface GigabitEthernet2/0/2! This
port is not a Trunk port!" indicates that the configuration failed on GigabitEthernet 2/0/2 because
GigabitEthernet 2/0/2 was not a trunk port; "Configuring GigabitEthernet2/0/3... Done" indicates that
the configuration on GigabitEthernet 2/0/3 succeeded.

port trunk pvid

Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094
Description
Use the port trunk pvid command to configure the default VLAN ID for the trunk port.
Use the undo port trunk pvid command to restore the default.
By default, the default VLAN of a trunk port is VLAN 1.
You can use a nonexistent VLAN as the default VLAN for a trunk port. Removing the default VLAN of a
trunk port with the undo vlan command does not affect the setting of the default VLAN on the port.
In port group view, this command applies to all ports in the port group. For more information about
port groups, see Ethernet Interface Configuration in the Layer 2 – LAN Switching Configuration
Guide.
In Layer 2 aggregate interface view, this command applies to the Layer 2 aggregate interface and
all its member ports. After you perform the configuration, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member
ports. If it fails to do that on an aggregation member port, it simply skips the port and moves to the
next port. For more information about Layer 2 aggregate interfaces, see Ethernet Link
Aggregation Configuration in the Layer 2 – LAN Switching Configuration Guide.
The local and remote trunk ports must use the same default VLAN ID for the traffic of the default
VLAN to be transmitted properly.
13-19