Mac-Vlan Mac-Address - H3C S7500E Series Command Reference Manual

View
Layer 2 Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the mac-vlan enable command to enable MAC address-based VLAN on a port.
Use the undo mac-vlan enable command to disable MAC address-based VLAN on a port.
By default, MAC address-based VLAN is disabled on a port.
Examples
# Enable MAC address-based VLAN on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname–GigabitEthernet2/0/1] mac-vlan enable

mac-vlan mac-address

Syntax
mac-vlan mac-address mac-address [ mask mac-mask ] vlan vlan-id [ priority pri ]
undo mac-vlan { all | mac-address mac-address [ mask mac-mask ] | vlan vlan-id }
View
System view
Default Level
2: System level
Parameters
mac-address mac-address: Specifies a MAC address.
mask mac-mask: Specifies a mask for the MAC address in the format of H-H-H. The mac-mask
argument is comprised of the high-order part (all the binary bits of which are 1s) and the low-order part
(all the binary bits of which are 0s). By default, the hexadecimal digits of this argument are all Fs.
vlan vlan-id: Specifies a VLAN ID, in the range of 1 to 4094.
priority pri: Specifies the 802.1p priority value corresponding to the specified MAC address. This
argument is in the range of 0 to 7.
all: Removes all the static MAC address-to-VLAN entries.
Description
Use the mac-vlan mac-address command to associate the specified VLAN and priority value with the
specified MAC addresses.
Use the undo mac-vlan command to remove the association.
Two MAC address-to-VLAN entry tables exist in a device. One table contains the MAC
address-to-VLAN entries configured with the mask keyword specified. A MAC address-to-VLAN entry
13-23