Table of Contents
Advertisement
Basics and mounting
Demounting > Demounting periphery module
2.6.3 Demounting periphery module
Remove connector
Replace the periphery
module
30
By means of a screwdriver there is the possibility to remove the connectors e.g. for
module exchange with a fix wiring. For this each connector has indentations for unlocking
at the top. Unlocking takes place by the following proceeding:
1.
Power-off your system.
CAUTION!
Make sure that the working contacts from the relay module are dis-
connected from the power supply!
2.
Remove connector:
Insert your screwdriver from above into one of the indentations.
3.
Push the screwdriver backwards:
ð The connector is unlocked and can be removed.
CAUTION!
Via wrong operation such as pressing the screwdriver down-
ward, the connector may be damaged!
4.
In this way, remove all plugged connectors on the periphery module.
1.
Remove the modules that are connected to the module to be replaced by pulling
their release levers outwards until these engage audible ...
2.
... and move the modules accordingly.
VIPA System MICRO
HB400 | CPU | M13-CCF0000 | en | 18-50
Advertisement
Table of Contents
