Table of Contents
Advertisement
Option: Deployment PROFIBUS communication
PROFIBUS communication via extension module EM M09
9.3 PROFIBUS communication via extension module EM M09
X2 MPI(PB)
Enable PROFIBUS func-
tionality
218
9pin SubD jack: (isolated)
The interface supports the following functionalities, which are switch able by an hardware
configuration:
n
MPI (default / after overall reset)
The MPI interface serves for the connection between programming unit and CPU. By
means of this the project engineering and programming happens. In addition MPI
serves for communication between several CPUs or between HMIs and CPU.
Standard setting is MPI address 2.
PROFIBUS DP slave (option)
n
The PROFIBUS slave functionality of this interface can be activated by configuring
the sub module 'MPI/DP' of the CPU in the hardware configuration.
The activation of the PROFIBUS functionality of the extension module EM M09 happens
with the following proceeding:
1.
Turn off the power supply.
2.
Mount the extension module.
3.
Switch on the power supply.
ð After a short boot time the interface X2 MPI(PB) is ready for MPI communica-
tion with the MPI address 2.
To switch the interface X2 MPI(PB) to PROFIBUS functionality
you have to activate the according bus functionality by means
of a VSC storage media from VIPA. By plugging the VSC
storage card and then an overall reset the according function-
ality is activated.
VSD, VSC' page 98
Ä Chap. 2.4 'Mounting' page 14
Ä Chap. 4.15 'Deployment storage media -
HB400 | CPU | M13-CCF0000 | en | 18-50
VIPA System MICRO
Advertisement
Table of Contents
