Table of Contents
Advertisement
Configuration with VIPA SPEED7 Studio
Deployment Web visualization > Start-up of the WebVisu project
Edit WebVisu
10.7.3
Start-up of the WebVisu project
252
In the 'Project tree' , navigate to 'WebVisu Project > Images' and click at 'Main' .
Select 'Context menu è Open image'
ð The WebVisu editor opens. Here, you can configure your web visualization by
dragging and dropping elements from the 'Catalog' onto the editor area and
using the 'Properties' to interconnect them with a variable.
The following preconditions must be fulfilled for the WebVisu project to start-up:
1.
Activate WebVisu functionality if not already done.
Visu functionality' page 249
2.
Configure your CPU and perform a hardware configuration.
3.
Configure your WebVisu project.
4.
Safe and translate your project.
5.
If you are online connected to your CPU, you can transfer your project to the CPU
with 'AG è Transfer all'.
ð Here the configuration is transferred in the CPU and the WebVisu project is
transferred to the memory card. Immediately after the transfer you have access
to your WebVisu.
You can use the CMD auto commands WEBVISU_PGOP_ENABLE and
WEBVISU_PGOP_DISABLE to enable or disable the WebVisu. After a
power cycle or loading a hardware configuration, the settings are
retained. With reset to the factory settings or over all reset, the WebVisu
project is set to the default value "enabled".
commands' page 102
VIPA System MICRO
Ä Chap. 10.7.1 'Activate Web-
Ä Chap. 4.17 'CMD - auto
HB400 | CPU | M13-CCF0000 | en | 18-50
Advertisement
Table of Contents
