Demounting Periphery Module - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO

2.6.3 Demounting periphery module

Remove connector
Replace the periphery
module
HB400 | CPU | M13-CCF0000 | en | 16-47
8. Reattach the extension module to the CPU by sliding the extension module on the
mounting rail to the right until the interface connector slightly locks into the CPU.
9. Move the locking levers back to the initial position.
10. Plug the corresponding bus connectors.
ð Now you can bring your system back into operation.
By means of a screwdriver there is the possibility to remove the connectors e.g. for
module exchange with a fix wiring. For this each connector has indentations for unlocking
at the top. Unlocking takes place by the following proceeding:
1. Power-off your system.
2. Remove connector:
Insert your screwdriver from above into one of the indentations.
3. Push the screwdriver backwards:
ð The connector is unlocked and can be removed.
CAUTION!
Via wrong operation such as pressing, the screwdriver down-
ward the connector may be damaged!
4. In this way, remove all plugged connectors on the periphery module.
1. Remove the modules that are connected to the module to be replaced by pulling
their release levers outwards until these engage audible ...
Basics and mounting
Demounting > Demounting periphery module
27