Table of Contents
Advertisement
VIPA System MICRO
11.3
TIA Portal - Hardware configuration - Ethernet PG/OP channel
Overview
Assembly and commis-
sioning
"Initialization" via Online
functions
HB400 | CPU | M13-CCF0000 | en | 18-50
The CPU has an integrated Ethernet PG/OP channel. This channel allows you to pro-
gram and remote control your CPU.
n
The Ethernet PG/OP channel (X3/X4) is designed as switch. This enables PG/OP
communication via the connections X3 and X4.
n
Configurable connections are possible.
DHCP respectively the assignment of the network configuration with a DHCP server
n
is supported.
n
Default diagnostics addresses: 2025 ... 2040
n
At the first commissioning respectively after a factory reset the Ethernet PG/OP
channel has no IP address. For online access to the CPU via the Ethernet PG/OP
channel, valid IP address parameters have to be assigned to this by means of your
configuration tool. This is called "initialization".
n
Via the Ethernet PG/OP channel, you have access to:
–
Device website, where you can find information on firmware status, connected
peripherals, current cycle times, etc.
–
WebVisu project, which is to be created in the SPEED7 Studio.
–
PROFINET IO controller or the PROFINET I-Device.
1.
Install your System MICRO with your CPU.
2.
Wire the system by connecting cables for voltage supply and signals.
3.
Connect the one of the Ethernet jacks (X3, X4) of the Ethernet PG/OP channel to
Ethernet.
4.
Switch on the power supply.
ð After a short boot time the CP is ready for communication. He possibly has no
IP address data and requires an initialization.
The initialization via the Online functions takes place with the following proceeding:
Determine the current Ethernet (MAC) address of your Ethernet PG/OP channel.
This can be found at the front of the CPU labelled as "MAC PG/OP: ...".
TIA Portal - Hardware configuration - Ethernet PG/OP channel
Configuration with TIA Portal
263
Advertisement
Table of Contents
