Demounting Periphery Modules - YASKAWA CPU 013C Manual

Basics and mounting
Demounting > Demounting periphery modules
Plug connector

2.6.2 Demounting periphery modules

Proceeding
Exchange of an electronic
module
Exchange of a periphery
module
30
Put the connector on the bottom edge and push it, as shown in the figure, with a
rotation upwards into the release lever until it engages.
ð Now you can bring your system back into operation.
1. Power-off your system.
2. For the exchange of a electronic module, the electronic module may be pulled for-
ward after pressing the unlocking lever at the lower side of the module.
3. For installation plug the new electronic module guided by the strips at the lower side
until this engages to the terminal module.
ð Now you can bring your system back into operation.
1. Power-off your system.
2. Remove if exists the wiring of the module.
3.
For demounting and exchange of a (head) module or a group of
modules, due to mounting reasons you always have to remove the
electronic module right beside. After mounting it may be plugged
again.
Press the unlocking lever at the lower side of the just mounted right module and pull
it forward.
4. Turn the locking lever of the module to be exchanged upwards.
VIPA System SLIO
HB300 | CPU | 013-CCF0R00 | en | 16-40