Status Indication - YASKAWA VIPA System MICRO Manual

Deployment I/O periphery
Pulse train > Status indication
Parameter overview
Operating parameters
Output format
Time base
On-delay
Period duration
Minimum pulse duration
*) This value can vary depending on the configuration tool and can be out of range. Values, which are out of range are invalid and must be adjusted accordingly!

5.9.5 Status indication

Digital output
DO +0.0
DO +0.1
154
Description
Here specify the range of values for the output. The CPU
hereby determines the pulse duration:
n Per mil
– Output value is within 0 ... 1000
– Pulse duration = (Output value / 1000) x period
duration
n S7 Analog value:
– Output value is Siemens S7 analog value 0 ...
27648
– Pulse duration = (Output value / 27648) x period
duration
Here you can set the time base, which will apply for resolu-
tion and range of values of the period duration, minimum
pulse duration and on-delay.
n 1ms: The time base is 1ms
n 0.1ms: Time base is 0.1ms
This parameter is ignored.
With period duration you define the length of the output
sequence, which consists of pulse duration and pulse
pause.
Range of values:
Time base 1ms: 1 ... 87ms
Time base 0.1ms: 0.4 ... 87.0ms
With the minimum pulse duration you can suppress short
output pulses and short pulse pauses. All pulses or
pauses, which are smaller than the minimum pulse dura-
tion, are suppressed. This allows you to filter very short
pulses (spikes), which can not be recognized by the
periphery.
Range of values:
Time base 1ms: 0 ... Period duration / 2 * 1ms
Time base 0.1ms: 2 ... Period duration / 2 * 0.1ms
LED
green
Description
Pulse train 0 has "1" signal
Pulse train 0 has "0" signal
Pulse train 1 has "1" signal
Pulse train 1 has "0" signal
VIPA System MICRO
Assignment
Per mil
0.1ms
0
50*
2
HB400 | CPU | M13-CCF0000 | en | 18-50