Table of Contents
Advertisement
Configuration with VIPA SPEED7 Studio
Deployment Web visualization
Operating parameters
Period
Minimum pulse duration
10.7
Deployment Web visualization
248
Description
With the period you define the length of the output
sequence, which consists of pulse duration and pulse
pause.
Range of values:
n
Time base 1ms: 1 ... 87ms
n
Time base 0.1ms: 0.4 ... 87.0ms
n
Time base 1µs: 1 ... 87µs
With the minimum pulse duration you can suppress short
output pulses and short pulse pauses. All pulses or
pauses, which are smaller than the minimum pulse dura-
tion, are suppressed. This allows you to filter very short
pulses (spikes), which can not be recognized by the
periphery.
Range of values:
n
Time base 1ms: 0 ... Period / 2 * 1ms
n
Time base 0.1ms: 2 ... Period / 2 * 0.1ms
n
Time base 1µs: 0 ... Period / 2 * 1µs
n
With a WebVisu project there is the possibility to configure a web visualization on your
CPU.
n
The configuration of a WebVisu project is only possible with the SPEED7 Studio V 1.7
and up.
n
Since a WebVisu project is only executable by memory card, a memory card of VIPA
(VSD, VSC) must be plugged.
Ä Chap. 4.15 'Deployment storage media - VSD, VSC' page 98
n
The WebVisu functionality must be activated in the CPU.
Ä Chap. 10.7.1 'Activate WebVisu functionality' page 249
n
When the project is transferred from the SPEED7 Studio, the WebVisu project is auto-
matically transferred to the inserted memory card.
n
Access happens by the IP address of the Ethernet PG/OP channel and the corre-
spondingly configured port or via the device web page
n
You can access your web visualization via a web browser. Web browsers based on
Windows CE are currently not supported.
Please note that the use of a WebVisu project, depending on the scope of
the WebVisu project and the PLC project, can influence the performance
and thus the response time of your application.
VIPA System MICRO
Assignment
50
2
HB400 | CPU | M13-CCF0000 | en | 18-50
Advertisement
Table of Contents
