Table of Contents
Advertisement
VIPA System MICRO
2.6.2 Demounting the extension module
Proceeding
HB400 | CPU | M13-CCF0000 | en | 18-50
1.
Power-off your system.
2.
Remove the corresponding bus connectors.
3.
Use a screwdriver to pull the locking levers of the extension module outwards until
these engage audible.
4.
Remove the extension module from the CPU by sliding it on the mounting rail.
5.
Remove the extension module with a rotation upwards from the mounting rail.
6.
Pull the locking levers of the extension module outwards until these engage
audible.
CAUTION!
It is not allowed to mount the module sideways on the mounting rail,
as otherwise the module may be damaged!
7.
Plug the extension module from the top onto the mounting rail and turn the exten-
sion module downward until it rests on the mounting rail.
8.
Reattach the extension module to the CPU by sliding the extension module on the
mounting rail to the right until the interface connector slightly locks into the CPU.
9.
Move the locking levers back to the initial position.
10.
Plug the corresponding bus connectors.
ð Now you can bring your system back into operation.
Basics and mounting
Demounting > Demounting the extension module
29
Advertisement
Table of Contents
