Table of Contents
Advertisement
Configuration with TIA Portal
TIA Portal - Hardware configuration - Ethernet PG/OP channel > Take IP address parameters in project
Assign IP address param-
eters
11.3.1
Take IP address parameters in project
2 variants for configura-
tion
264
You get valid IP address parameters from your system administrator. The assignment of
the IP address data happens online in the Siemens TIA Portal with the following pro-
ceeding:
1.
Start the Siemens TIA Portal.
2.
Switch to the 'Project view' .
3.
Click in the 'Project tree' at 'Online access' and choose here by a doubleclick your
network card, which is connected to the Ethernet PG/OP channel.
4.
To get the stations and their MAC address, use the 'Accessible device' . This can
be found at the front of the CPU labelled as "MAC PG/OP: ...".
5.
Choose from the list the module with the known MAC address (Onboard PG/OP
[MAC address]) and open with "Online & Diagnostics" the diagnostics dialog in the
Project area.
6.
Navigate to Functions > Assign IP address. Type in the IP configuration like IP
address, subnet mask and gateway.
7.
Confirm with [Assign IP configuration].
ð Directly after the assignment the Ethernet PG/OP channel is online reachable
using the set IP address data. The value remains as long as it is reassigned, it
is overwritten by a hardware configuration or an factory reset is executed.
Due to the system you may get a message that the IP address could not
be assigned. This message can be ignored.
From firmware version V. 2.4. and up, you have the following options for configuring the
Ethernet PG/OP channel:
n
Configuration via integrated CPU interface (firmware version V. 2.4. and up only).
n
Configuration via additional CP (all firmware versions).
VIPA System MICRO
HB400 | CPU | M13-CCF0000 | en | 18-50
Advertisement
Table of Contents
