Demounting Periphery Modules - YASKAWA CP 040 RS422/485 Manual

VIPA System SLIO

2.7 Demounting periphery modules

Proceeding
Exchange of an electronic
module
Exchange of a periphery
module
HB300 | CP | 040-1CA00 | en | 18-28
3. Attach the cables with the accordingly stripped cable screen and fix it by the shield
clamp with the shield bus.
1. Power-off your system.
2. For the exchange of a electronic module, the electronic module may be pulled for-
ward after pressing the unlocking lever at the lower side of the module.
3. For installation plug the new electronic module guided by the strips at the lower side
until this engages to the terminal module.
ð Now you can bring your system back into operation.
1. Power-off your system.
2. Remove if exists the wiring of the module.
3.
For demounting and exchange of a (head) module or a group of
modules, due to mounting reasons you always have to remove the
electronic module right beside. After mounting it may be plugged
again.
Press the unlocking lever at the lower side of the just mounted right module and pull
it forward.
Basics and mounting
Demounting periphery modules
25