Pulse Train - YASKAWA VIPA System MICRO Manual

Configuration with VIPA SPEED7 Studio
Deployment I/O periphery > Pulse train
10.6.8

Pulse train

10.6.8.1 Overview
10.6.8.2 Parametrization in SPEED7 Studio
10.6.8.2.1 'I/O addresses'
Sub module Input address
Count 816
820
824
828
Sub module Output address
Count 816
820
824
828
10.6.8.2.2 'Channel x'
Operating mode
246
2 channels
n
n Sub module 'Count'
n Control by the user program via SFB 49
Ä Chap. 5.9 'Pulse train' page 151
n
Access
DINT
DINT
DINT
DINT
Access
DWORD
DWORD
DWORD
DWORD
PWM and pulse train output use the same hardware configuration. Switching between
these modes is done within the SFB 49. Select via 'Channel x' the channel and select for
pulse train via 'Operating mode' the operating mode 'Pulse width modulation' . Default
values and structure of this dialog box depend on the selected 'Operating mode' . The fol-
lowing parameters are are relevant for pulse train, which must be specified or deter-
mined:
Assignment
reserved
reserved
reserved
reserved
Assignment
reserved
reserved
reserved
reserved
HB400 | CPU | M13-CCF0000 | en | 18-50
VIPA System MICRO