Table of Contents
Advertisement
Deployment CPU M13-CCF0000
Deployment storage media - VSD, VSC
4.15
Deployment storage media - VSD, VSC
Overview
98
3.
After the 6. static light release the operating mode switch and tip it downwards to
MR.
ð To confirm the reset process the yellow LED of the status bar blinks (2Hz)
. This means that the RAM was deleted completely.
If the yellow LED of the status bar is on
overall reset has been performed and the reset to factory set-
ting has been failed. In this case you can repeat the procedure.
A factory reset can only be executed if the yellow LED has
static light for exact 6 times.
4.
The reset process is completed when the red and yellow LEDs of the status bar are
blinking (1Hz)
5.
Turn power OFF and ON.
After a firmware update of the CPU you always should execute a factory
reset.
At the front of the CPU there is a slot for storage media. Here the following storage media
can be plugged:
n
VSD - VIPA SD-Card
–
External memory card for programs and firmware.
n
VSC - VIPASetCard
–
External memory card (VSD) for programs and firmware with the possibility to
unlock optional functions like work memory and field bus interfaces.
–
These functions can be purchased separately.
–
To activate the corresponding card is to be installed and a Overall reset is to be
established.
Ä Chap. 4.12 'Overall reset' page 94
To avoid malfunctions, you should use memory cards of VIPA. These cor-
respond to the industrial standard. A list of the currently available VSD
respectively VSC can be found at www.vipa.com
You can cause the CPU to load a project automatically respectively to execute a com-
mand file by means of pre-defined file names.
.
HB400 | CPU | M13-CCF0000 | en | 18-50
VIPA System MICRO
, only an
Advertisement
Table of Contents
