YASKAWA VIPA System MICRO Manual page 178

Deployment PG/OP communication - productive
Configure Open Communication
UDTs
FB Designation
UDT 65* TCON_PAR
UDT 66* TCON_ADR
More information about the usage of these blocks may also be found in the manual "SPEED7 Operation List" from VIPA
*)
FBs
FB Designation
FB 63* TSEND
FB 64* TRCV
FB 65* TCON
FB 66* TDISCON
FB 67* TUSEND
FB 68* TURCV
More information about the usage of these blocks may also be found in the manual "SPEED7 Operation List" from VIPA.
*)
178
Hardware configuration:
n CPU
Ä Chap. 4.4 'Hardware configuration - CPU' page 68
n Ethernet PG/OP channel
Ä Chap. 4.6 'Hardware configuration - Ethernet PG/OP channel' page 71
To specify the Ethernet PG/OP channel, the following values are defined in the UDT 65:
n local_device_id
– 00h: Ethernet PG/OP channel of the CPU
n next_staddr_len
– 01h: Ethernet PG/OP channel of the CPU
n next_staddr
– 04h: Ethernet PG/OP channel of the CPU
Connection-oriented protocols:
TCP native as per RFC 793, ISO
on TCP as per RFC 1006
Data structure for assigning connec-
tion parameters
Connection-oriented protocols:
TCP native as per RFC 793, ISO
on TCP as per RFC 1006
Sending data
Receiving data
Establishing a connection
Terminating a connection
VIPA System MICRO
Connectionless protocol: UDP
according to RFC 768
Data structure for assigning parameters
for the local communications access point
Data structure for assigning addressing
parameters for the remote partner
.
Connectionless protocol: UDP
according to RFC 768
Configuring the local communications
access point
Closing the local communications access
point
Sending data
Receiving data
HB400 | CPU | M13-CCF0000 | en | 18-50