Fast Introduction; Hardware Configuration - YASKAWA VIPA System MICRO Manual

Deployment PG/OP communication - productive

Hardware configuration

6.6 Fast introduction

Overview
Steps of configuration
6.7 Hardware configuration
Overview
170
At the first commissioning respectively after an overall reset with PowerON again of the
CPU, the Ethernet PG/OP channel has no IP address. This can only be reached by its
MAC address. By means of the MAC address, which is printed at the front as 'MAC PG/
OP:...' , you can assign IP address data. The assignment takes place directly via the
hardware configuration of the Siemens SIMATIC Manager.
For the configuration of the Ethernet PG/OP channel for productive connections please
follow the following approach:
n Hardware configuration - CPU
n Hardware configuration - Ethernet PG/OP channel
n Configure connections
– Siemens S7 connections
(Configuration via Siemens NetPro, communication via VIPA handling blocks)
– Open communication
(Configuration and communication happens by standard handling blocks)
n Transfer of the complete project to CPU
At the first commissioning respectively after an overall reset with PowerON again of the
CPU, the Ethernet PG/OP channel has no IP address. This can only be reached by its
MAC address. By means of the MAC address, which is printed at the front as 'MAC PG/
OP:...' , you can assign IP address data. The assignment takes place directly via the
hardware configuration of the Siemens SIMATIC Manager.
n CPU
Ä Chap. 4.4 'Hardware configuration - CPU' page 68
n Ethernet PG/OP channel
Ä Chap. 4.6 'Hardware configuration - Ethernet PG/OP channel' page 71
VIPA System MICRO
HB400 | CPU | M13-CCF0000 | en | 18-50