Activate Webvisu Functionality; Webvisu Editor - YASKAWA VIPA System MICRO Manual

VIPA System MICRO
10.7.1

Activate WebVisu functionality

Proceeding
10.7.2

WebVisu editor

HB400 | CPU | M13-CCF0000 | en | 18-50
For your CPU can process a WebVisu project, you have to activate the WebVisu function-
ality.
1. Insert a memory card from VIPA (VSD, VSC) into your CPU.
ment storage media - VSD, VSC' page 98
2. Turn on the CPU, to activate the WebVisu functionality, you have to establish an
Overall reset.
ð As long as the memory card is inserted, the WebVisu functionality remains acti-
vated even after a power cycle. When the project is transferred from the
SPEED7 Studio, the WebVisu project is automatically transferred to the inserted
memory card.
Please regard that the memory card must remain plugged when
you've executed activated the WebVisu functionality. Otherwise
the red LED of the status bar
and the WebVisu functionality is deactivated after 72 hours. As
long as an activated memory card is not inserted, the LED
blinks and the "TrialTime" timer counts from 72 hours down to 0.
After that the WebVisu functionality is de-activated. By inserting
the memory card, the LED goes off and the CPU runs again
without restrictions.
The configuration of a WebVisu project is shown below. This is only the basic use of the
WebVisu editor in the SPEED7 Studio together with the VIPA CPU. Please note that soft-
ware changes can not always be considered and it may thus be deviations to the descrip-
tion.
For more information on the SPEED7 Studio and how to use the Web-
Visu editor, refer to its online help.
Configuration with VIPA SPEED7 Studio
Deployment Web visualization > WebVisu editor
Ä Chap. 4.15 'Deploy-
blinks with 1Hz in RUN
249