Setting Limits - Siemens SINAMICS S210 Operating Instructions Manual

6.2.4

Setting limits

When required, you can configure limits for elements of your converter and adapt to the
requirements of your mechanical system in the "Parameters - Limits" view.
Figure 6-15
Setting limits
1. Select "Parameters > Limits" in the navigation.
The table below the graphic shows the "Maximum speed" line of the speed limitation.
2. Enter the maximum speed in the input field of the same name.
3. Enter the two torque limit values.
– "Torque limit, upper"
– "Torque limit, lower"
4. Click
SINAMICS S210 servo drive system
Operating Instructions, 01/2019, A5E41702836B AC
Parameters - Limits
to save the data permanently.
Commissioning and diagnostics using the web server
6.2 Commissioning using the web server
201