Siemens SINAMICS S210 Operating Instructions Manual page 493

Cause: At least one function module requiring a license is not licensed.
Fault value (r0949, interpret hexadecimal):
Bit x = 1: The corresponding function module does not have a license.
Note:
Assigning bit number to function module, see p0108 or r0108.
Remedy: - enter and activate the license key for function modules that require a license license (p9920, p9921).
- if necessary, deactivate unlicensed function modules (p0108, r0108).
A13021 Licensing for output frequencies > 550 Hz missing
Reaction: NONE
Acknowledge: NONE
Cause: Configuring the converter results in an output frequency greater than 550 Hz. This function requires a license. The "High
Output Frequency" license is required.
Note:
- in this specific case, the output frequency is limited to 550 Hz.
- the "Trial License" function is not effective for license "High Output Frequency".
Remedy: - enter and activate the license key for "High Output Frequency" and activate (p9920, p9921).
- if necessary operate the motor below the output frequency of 550 Hz.
A13030 Trial License activated
Reaction: NONE
Acknowledge: NONE
Cause: The "Trial License" function was activated. One of the available periods is expiring.
Remedy: Not necessary.
The alarm is automatically withdrawn after the periods have expired.
A13031 Trial License period expired
Reaction: NONE
Acknowledge: NONE
Cause: One of the available periods of the "Trial License" function has expired.
Remedy: - if required, start an additional period (p9918 = 1).
- deactivate functions requiring a license.
- appropriately license the drive unit.
Note:
A license that is not adequate will only become evident after the next time the system runs up.
A13032 Trial License last period activated
Reaction: NONE
Acknowledge: NONE
Cause: The "Trial License" function was activated. The last of the available periods is expiring.
Remedy: Not necessary.
The alarm is automatically withdrawn after the last period has expired.
A13033 Trial License last period expired
Reaction: NONE
Acknowledge: NONE
Cause: The last period of the "Trial License" function has expired. No additional periods available.
SINAMICS S210 servo drive system
Operating Instructions, 01/2019, A5E41702836B AC
Faults and alarms
15.2 List of faults and alarms
491