Service And Maintenance For The Converter; Converter Firmware Update - Siemens SINAMICS S210 Operating Instructions Manual

Service and maintenance

9.2 Service and maintenance for the converter

9.2 Service and maintenance for the converter
9.2.1

Converter firmware update

You have the option of upgrading your converter (upgrade) to a newer firmware version. You
can also install an older firmware version (downgrade) to always provide the same machine
configurations.
For an upgrade, the settings previously made are kept.
For a downgrade, the converter is reset to the factory settings.
NOTICE
Malfunctions due to interruption of the power supply or disconnecting the motor when
updating the firmware
If the firmware is being updated, interrupting the power supply or disconnecting the motor, can
result in defects or cause the devices to malfunction.
● Observe the information provided about the LEDs.
The firmware can be updated via the web server as well as without web server with memory
card.
Updating the firmware via the web server
A description of the firmware update via the web server is provided in the following section.
Firmware update via memory card
Requirements
● You have an SD card with the appropriate firmware, e.g. 6SL3054-4FC00-2BA0.
● You have an empty SD card with a maximum capacity of 2 GB (e.g. 6SL3054-4AG00-2AA0)
on which you can load the firmware.
You can find the firmware versions available at the following link:
Firmware versions (https://support.industry.siemens.com/cs/ww/en/view/109744577)
Procedure
Proceed as follows to update the firmware using the memory card:
1. Switch off the converter.
2. Insert the SD card into the converter and switch on the converter.
268
Updating the firmware via the web server (Page 246)
SINAMICS S210 servo drive system
Operating Instructions, 01/2019, A5E41702836B AC