Installing The Motor; Checklists Prior To Assembly - Siemens SINAMICS S210 Operating Instructions Manual

Installing

5.2 Installing the motor

5.2 Installing the motor
5.2.1

Checklists prior to assembly

Note
Required checks
The checks listed below are a minimum benchmark and must be performed in any case.
Further checks before, during and after the installation of the motor depend on the system-
specific conditions and are the responsibility of the plant or system manufacturer.
● Thoroughly familiarize yourself with the safety instructions and observe the checklists below
before starting any work.
Table 5-1
General checks
Are the environmental conditions in the permissible range?
Checks regarding the mechanical system
Is the motor free of visible damage?
Have the mounting surfaces (e.g. flange, shaft) on the customer machine and on the
motor been cleaned?
Are the mounting surfaces free of corrosion?
Do the mounting dimensions (e.g. shaft diameter, shaft length, true run) on the customer
machine meet the specification?
140
Checklist
Chapter Permissible environmental conditions for the motor (Page 280).
Check
Operating Instructions, 01/2019, A5E41702836B AC
OK
SINAMICS S210 servo drive system