Setting Parameters; Introduction To Basic Operator Panel (Bop) - Siemens MICROMASTER 440 Quick Start Manual

5

Setting Parameters

5.1 Introduction to Basic Operator Panel (BOP).

There are several types of parameters that can be changed on a MICROMASTER 440. This
procedure describes how to use the BOP to change parameters. There are also read-only parameters
denoted by rXXXX for information/monitoring purposes.
5.1.1 Changing a "normal" parameter.
Step
1 Press
in order to access list of parameters.
2 Press
to select the parameter that you want to change.
3 Press
to access that parameter's contents
4 Press
or to scroll to desired setting
5 Press
to confirm and save the setting
6 Repeat steps 1 to 5 until all desired parameters are changed
NOTE: In this example, the user can only see the command parameters.
5.1.2 Changing an indexed parameter
Step
1 Press
in order to access list of parameters.
2 Press
to select the parameter that you want to change.
3 Press
in order to reach the index number
Press or in order to scroll to the required index
4 Press
in order to display the current setting
5 Press
or to scroll to desired setting
6 Press
to confirm and save the setting
7 Press or to scroll to next desired parameter & repeat
steps 2 to 6
8 Press
to scroll back down to r0000
9 Press
to exit the parameter changing menu
MICROMASTER 440
6SE6400-5GA00-0BP0
Quick Start Guide
Issue 08/03
Example of the display
Example of the display
43