Siemens SINAMICS S210 Operating Instructions Manual page 262

Diagnostics
8.2 Message classes in accordance with PROFIdrive
Message
class
"Channel Error Type" of the PROFINET channel diagnostics. When channel diagnostics is activated,
1)
then the fault texts are indicated in the PLC.
260
PN Explanation of the message class according to PROFIdrive -
1)
(hex) cause and remedy.
18 9011 Error in the parameterization/configuration/commissioning sequence
An error has been identified in the parameterization or in a commissioning
procedure, or the parameterization does not match the actual device configu‐
ration.
● Determine the precise cause of the fault using the commissioning tool.
● Adapt the parameterization or device configuration.
19 9012 General drive fault
Group fault.
● Determine the precise cause of the fault using the commissioning tool.
SINAMICS S210 servo drive system
Operating Instructions, 01/2019, A5E41702836B AC