Siemens SINAMICS S210 Operating Instructions Manual page 389

Note
If, within this time, no setting values can be determined, then the drive is shut down with the corresponding fault.
r5600 Pe energy-saving mode ID
Data type: Integer16
Description: Displays the PROFIenergy mode ID of the effective energy-saving mode.
Value: 0:
2:
240:
255:
Note
Pe: PROFIenergy profiles
For value = 0: This value is displayed in the "First commissioning" state.
p5611 Pe energy-saving properties general
Can be changed: T
Min: -
Description: Sets the general properties for energy-saving.
Bit field: Bit
00
Note
Pe: PROFIenergy profiles
r8936[0...1] Cyclic connection status
Data type: Integer16
Description: Displays the status of cyclic connections.
Value: 0:
1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
Index: [0] = Controller 1
[1] = Controller 2
SINAMICS S210 servo drive system
Operating Instructions, 01/2019, A5E41702836B AC
POWER OFF
Energy-saving mode
Operation
Ready
Signal name
Inhibit PROFIenergy control commands
Interrupted
Not connected
Connection starts to be established
Module information expected
Module information received
Module address expected
Module address received
Parameterization data expected
Parameterization data received
Evaluate parameterization data
Connection being established completion expected
Configured controller RUN expected
Configured controller STOP
Configured controller RUN
Unit: -
Data type: Unsigned32
Max: -
Unit: -
Parameters
14.2 List of parameters
Def: 0000 bin
1 signal 0 signal
Yes No
387