Synchronous Parameter Setting Errors (From 00F0 5000H) - Panasonic AFP7MC16EC User Manual

Troubleshooting

15.3.6 Synchronous Parameter Setting Errors (From 00F0 5000H)

 Synchronous parameter: Common errors
Error
Error name
code
Synchronous master
5000H
setting value error
Synchronous setting
5002H
disable error
Synchronous slave
single deceleration
5006H
stop deceleration
time
(Note): To simplify the displays, only the lower four digits (Hex) of each error code are displayed in the above table.
 Synchronous parameter: Electronic gear related errors
Error
Error name
code
Electronic gear -
Gear ratio
5100H
numerator setting
error
Electronic gear -
Gear ratio
5101H
denominator setting
error
Electronic gear-
5102H Gear ratio change
time setting error
(Note): To simplify the displays, only the lower four digits (Hex) of each error code are displayed in the above table.
15-22
Description
The setting for the synchronous
master axis is incorrect.
- Setting error (Value is
incorrect.)
- Own axis setting
The synchronous setting
request was made in the
following axis setting.
- Its own axis (slave axis) is set
as the master of another axis.
- The master axis is set as the
slave axis of another axis.
- Its own axis (slave axis)
belongs to the interpolation
group.
The setting for the synchronous
slave single deceleration stop
time is incorrect.
Description
The setting for the gear ratio
numerator of the electronic gear
is incorrect.
The setting for the gear ratio
denominator of the electronic
gear is incorrect.
The setting for the gear ratio
change time of the electronic
gear is incorrect.
●: Recoverable, -: Unrecoverable
Object Recovered
Each

axis
Check the set value.
If the error occurs repeatedly
Each
with the correct set values,

axis
please contact us.
Each

axis
●: Recoverable, -: Unrecoverable
Object Recovered
Each

axis
Check the set value.
If the error occurs repeatedly
Each

with the correct set values,
axis
please contact us.
Each

axis
Countermeasures
Countermeasures