Isuzu N Series 2008 Owner's Manual page 76

2-46
IMPORTANT INFORMATION
Either the 4H or 4L gear can be selected with this switch when operating in 4WD
mode. Select either gear appropriately depending on driving conditions.
Gear Switching Method
Use the transfer gear control switch to switch the gear from 2H-4H to 4L and vice
versa. Be sure to stop the vehicle and press the clutch pedal when you make such a
selection.
2H-4H
(for high-speed
driving)
4L
(for low-speed
driving)
ADVICE
• This vehicle is designed to prevent the LOW gear from being selected even
when the LOW side of the transfer gear control switch is pressed while driving
in 2WD mode. Before you can switch from 4H to 4L, the 4WD switch must be
set to the 4WD position.
• Switching the gear from 4WD to 2WD using the 4WD switch is possible only
when the HIGH side of the transfer gear control switch is selected. Before you
can switch the mode to 2WD, the vehicle must be stopped and the transfer gear
control switch must be in the HIGH position.
2008N_sec02_print2.indd 46
Transfer Gear Control Switch
Switch position
V
Usage conditions
Use this position for normal
driving in 2WD mode. If two-
wheel driving becomes difficult on
snow-covered, icy, soft, or sandy
surfaces, move the 4WD switch
to the 4WD position while keeping
the transfer gear control switch at
"HIGH".
Select the "LOW" side of the
transfer gear control switch when
moving off or driving in 4WD
mode on steep, uphill inclines,
soft surfaces, or other situations
where a particularly large torque is
required.
15/09/2008 10:36:49 AM