Isuzu N Series 2008 Owner's Manual page 219

AMT Warning Light and Warning Buzzer Operation
The AMT warning light comes on or flashes and the warning buzzer sounds to warn
you of the following conditions.
Condition and alarm type
The driver opens the door
and is leaving the vehicle
with the starter switch in
the "ON" position and the
transmission in gear.
The accelerator pedal is
kept depressed while the
brakes are being applied.
The vehicle is stopped on
a slope with the accelerator
pedal kept depressed.
The vehicle continues to be
driven in an inappropriate
gear. *
The vehicle is started and
stopped too frequently.
The vehicle is driven with
the parking brake lever
pulled up or the vehicle is
stopped by pulling up the
parking brake lever with the
transmission in gear for a
long time.
The PTO is being used.
The AMT system has failed.
2008N_sec04-2_print2.indd 91
CONTROLS AND INSTRUMENTS
AMT
warning light
Warning
buzzer
Short,
— repeated
beeps
Short,
— repeated
beeps
Short,
— repeated
beeps
Short,
— repeated
beeps
Short,
— repeated
beeps
Short,
— repeated
beeps
Short, slow
—
beeps
Continuous
beep
Short,
Comes on
repeated
beeps
—
Corrective action
Return the gearshift lever to the
"N" position and set the parking
brake.
Release the accelerator pedal
or return the gearshift lever to
the "N" position.
Release the accelerator pedal
and apply the brakes.
Release the accelerator pedal
or shift down to an appropriate
gear and drive in the manual
mode.
Stop the vehicle at a safe
place, return the gearshift lever
to the "N" position and run the
engine at idle to cool it down.
Release the parking brake. Or
return the gearshift lever into
the "N" position.
—
Stop the vehicle at a safe
place and have your vehicle
inspected at the nearest Isuzu
Dealer promptly.
4-91
3/09/2008 5:31:44 PM