Oil
surface
2008N_sec07-2_print2.indd 107
SERVICE AND MAINTENANCE
Changing the Oil
Level check
plug hole
Oil level
(lower edge of level
check plug hole)
HCU7C0SH005201
1. Place a container under the drain
plug(s) to receive oil.
2. Remove both oil level plug and drain
plug(s) to discharge the oil into the
container.
3. After installing the drain plug(s) by
tightening it to the specified torque,
refill the transmission with new oil
through the oil level plug hole up to
the lower edge of the hole.
Drain plug tightening torque
39 N·m (4.0 kgf·m/29 lb·ft)
ADVICE
•
The dirt on the plug should be wiped
off before installing it.
4. After refilling, confirm that the oil level
is up to the lower edge of the oil level
plug hole.
7-107
3/09/2008 5:53:46 PM