Isuzu N Series 2008 Owner's Manual page 284

4-156
CONTROLS AND INSTRUMENTS
2. In a manual transmission model, place the gearshift lever into the "N" position
and firmly engage the parking brake.
In a AMT model, place the gearshift lever into the "N" position, confirm the "N"
indication and securely pull the parking brake.
3. Run the engine at idle.
If your vehicle is equipped with an idling control knob, return it fully
counterclockwise to decrease the engine speed when the engine speed has been
increased using the idling control knob.
4. Stop the operation of PTO if your vehicle is equipped with a PTO. Turn off the
PTO switch and the outside accelerator control.
Model without MID
(Amber)
Model with MID
(Amber)
2008N_sec04-2_print2.indd 156
DPD Manual Regeneration Procedure
1. Stop the vehicle at a safe place free
of flammable materials such as dead
grass or wastepaper.
CAUTION
• To prevent a fire, make sure that
there is no flammable material near
the muffler, DPD and exhaust pipe.
Remember that the temperature of
exhaust gases is high enough to
burn you.
5. Press the DPD switch.
6. If your vehicle is not equipped with a
multi-information display (MID), the
DPD manual regeneration indicator
light (amber) stops flashing and
stays on, and the engine speed
automatically increases to start
regeneration. If your vehicle is
equipped with a MID, the "PUSH
DPD SWITCH" message (amber)
stops flashing and change to a
steady "MANUAL REGEN." message
(amber), and the engine speed
automatically increases to start the
regeneration.
7. Do not leave the vehicle during the
regeneration. Regeneration normally
completes in about 20 minutes.
3/09/2008 5:32:20 PM