3-6
DOORS, WINDOWS AND SEATS
Replacing the Battery in the Remote Control Unit
2008N_sec03_print2.indd 6
1. Remove the key ring from the remote
control unit. Remove the cover by
removing the screw with a small
screwdriver.
2. Take out the battery holder, and then
remove the battery from the holder.
3. Install a new battery (CR2032, 3 V) in
the battery holder with the "+" mark
side facing up and place the holder in
position in the cover.
ADVICE
•
When closing the cover, check that
there is no dust, hair or anything
else caught underneath it. A poorly
sealed remote control unit could
become deteriorated.
4. Close the cover, and then fasten the
cover with the screw. Install the key
ring on the remote control unit.
3/09/2008 4:35:42 PM