Isuzu N Series 2008 Owner's Manual page 205

CAUTION
• Although the parking brake warning light will come on if the parking brake is
engaged while the starter switch is in the "ON" position, this does not mean the
parking brake is fully engaged, so always make sure the lever is fully pulled up.
• Simply pressing the release button does not return the lever to its original
position. You should always press the release button while pulling the parking
brake lever up slightly.
• If the vehicle is parked facing up a hill, place the gearshift lever in the "1 (1st)"
gear, and if parked facing down a hill, place the lever in the "R (reverse)" gear.
In addition, chocks must always be applied in either of these situations.
• Never park the vehicle on a steep slope.
Parking brake warning light
2008N_sec04-2_print2.indd 77
CONTROLS AND INSTRUMENTS
Parking Brake Lever
Operation of Parking Brake
Apply the parking brake lever fully when
parking the vehicle. The parking brake
warning light in the instrument panel will
come on when the lever is pulled up.
To release the parking brake, press the
release button while raising the lever a little
and then lower the lever. The parking brake
warning light in the instrument panel will go
out.
4-77
3/09/2008 5:31:36 PM