Isuzu N Series 2008 Owner's Manual page 448

7-102
SERVICE AND MAINTENANCE
Bleeding the Clutch Hydraulic System
If air is present in the clutch hydraulic system, the clutch may disengage incompletely.
Bleed the system if the clutch is used when the quantity of the clutch fluid in the tank is
extremely low or the clutch piping is disconnected during a maintenance operation. Do
not perform bleeding by yourself; it should be done with the help of another person.
2008N_sec07-2_print2.indd 102
1. Chock the wheels and firmly apply the
parking brake.
2. Check the level of the clutch fluid in
the clutch fluid tank and add fluid as
required.
3. Detach the rubber cap from the
bleeder screw on the clutch slave
cylinder. Wipe the bleeder screw
clean.
4. Attach one end of a vinyl tube to the
bleeder screw and put the other end
in a clear container. Fill the container
with clutch fluid to about one-third (1/3)
of its capacity.
3/09/2008 5:53:42 PM