Isuzu N Series 2008 Owner's Manual page 269

NOTE
• A PTO gear grinding noise may occur when the dump control lever is moved
back to the "UP" position in order to raise the dump body after it has been
moved to the "DOWN" position. This does not indicate any abnormal condition.
The gear grinding noise can be avoided, however, by returning the lever to the
"DOWN" position, pressing the PTO switch to stop the warning buzzer, again
pressing the PTO switch and then operating the dump control lever.
2008N_sec04-2_print2.indd 141
CONTROLS AND INSTRUMENTS
When Lowering the Dump Body
(Model with AMT)
1. Press the lock button on the dump
control lever, and move the lever
from the "UP" position to the "DOWN"
position. The dump body will lower by
gravity.
2. Press the PTO switch. The buzzer will
stop sounding.
When Lowering the Dump Body
(Manual Transmission Model)
Press the lock button on the dump control
lever, and move the lever from the "UP"
position to the "DOWN" position. The dump
body will lower by gravity.
At this time, the PTO indicator light in the
instrument panel will go out.
4-141
3/09/2008 5:32:11 PM