Isuzu N Series 2008 Owner's Manual page 550

8-30
IN CASE OF EMERGENCY
2008N_sec08_print2.indd 30
Replacing a Turn Signal Light
(NLR/NNR/NPR/NQR/NPS Models)
1. While referring to "Replacing the
Headlights", tilt the turn signal light
unit down toward the front of the
vehicle and remove it.
Replacing the Headlights
→ Refer to page 8-25
2. Disconnect the connector for the
turn signal light and then remove the
socket.
3. Pull off the bulb from the socket and
replace with a new one.
4. To install the lights, perform the same
sequence of operations in reverse
taking care of the following points:
• Turn the socket clockwise to
securely lock it.
ADVICE
• If the socket is not locked securely,
water could get inside the light and
lead to a breakdown.
4/09/2008 8:14:29 AM