Isuzu N Series 2008 Owner's Manual page 452

7-106
SERVICE AND MAINTENANCE
Oil
surface
2008N_sec07-2_print2.indd 106
Checking the Oil Level
Level check
plug hole
Oil level
(lower edge of level
check plug hole)
HCU7C0SH005201
1. Remove the oil level plug.
2. Check whether the oil level is up to
the lower edge of the oil level plug
hole. The correct oil level range is
between 0 and 10 mm (0 and 0.39
in) below the bottom of the level plug
hole.
If the oil level is too low, add oil
through the oil level plug hole.
3. Fasten the oil level plug to the
specified torque.
Also check to see if there are any
transmission oil leaks.
Oil level plug tightening torque
39 N·m (4.0 kgf·m/29 lb·ft)
ADVICE
• Any dirt on the plug should be wiped
off before installing it.
3/09/2008 5:53:45 PM