Isuzu N Series 2008 Owner's Manual page 158

4-30
CONTROLS AND INSTRUMENTS
2008N_sec04-1_print2.indd 30
How to Set a New Change Interval
(Odometer Reading) for Engine Oil
and Filter
1. On the MID, go to ENG OIL & FILTER
screen.
2. Enter the setting change screen by
pressing and holding the MID select
knob.
NOTE
• If you want to cancel the setting
procedure, press the MID select
knob once. The display goes back
to the screen that was displayed just
before entering the setting change
screen.
3. Pressing and holding the MID select
knob sets the new change time
(distance).
How to Set a New Change
Time (Odometer Reading) for
Transmission Oil, AMT Clutch Oil
(AMT Equipped Model), Fuel Filter
and Power Steering Fluid
1. On the MID, go to the screen for the
maintenance item for which you want
to adjust.
2. Enter the setting change screen by
pressing and holding the MID select
knob.
NOTE
• If you want to cancel the setting
procedure, press the MID select
knob once. The display goes back
to the screen that was displayed just
before entering the setting change
screen.
3/09/2008 5:28:28 PM