Isuzu N Series 2008 Owner's Manual page 221

How to Adjust Partial Clutch Engagement of AMT
With the AMT system, you can select the desired degree of partial clutch engagement
from the 4 positions in both the fast and slow engagement directions from the default
(standard) setting. You need to make an adjustment in the following cases.
• If clutch engagement is too fast or too slow when you start the vehicle.
• The timing of clutch engagement does not agree with your preference.
2008N_sec04-2_print2.indd 93
CONTROLS AND INSTRUMENTS
Adjustment
1. With the engine running, pull up the
parking brake lever and place the
gearshift lever into the "N" position.
2. Press the "FAST" side or "SLOW" side
of the AMT adjustment switch. If you
feel the clutch slip, press the "FAST"
side. If you feel the clutch engages
abruptly, push the "SLOW" side.
Select your desired position from the
4 plus (+) stages and the 4 minus (-)
stages with the centre position as the
default. This makes nine stages total.
3. Each time you press the adjustment
switch, a buzzer beeps once, showing
you that one step of adjustment has
completed. If you want to make
another step of adjustment, release
the switch and press it again. The
buzzer beeps again, showing you
that the next adjustment has been
completed.
4-93
3/09/2008 5:31:44 PM