Isuzu N Series 2008 Owner's Manual page 231

2008N_sec04-2_print2.indd 103
CONTROLS AND INSTRUMENTS
Adjustment
1. Pull the parking brake lever, make
sure the gearshift lever is placed in
the "N" position and then start the
engine. At this time make sure that
the HSA OFF switch is placed in
"OFF" and that HSA is enabled.
2. Fully depress the brake pedal and
release the parking brake lever.
Check that the HSA indicator light
comes on and then depress the clutch
pedal and place the gearshift lever
into a position other than "N".
3. If the HSA releases the brakes too
slowly and the brakes drag when
starting the vehicle, press the "FAST"
side of the HSA adjustment switch. If
the HSA releases the brakes too early
and the vehicle moves down a slope
when restarting the vehicle, press the
"SLOW" side of the switch. Every
time the switch is pressed, a buzzer
sounds.
4. Repeat Step 3 above until the brakes
are released when desired.
4-103
3/09/2008 5:31:50 PM